Hello Dears,
im trying to configure redundent links, auto failover between two sites( one site has Juniper SSG350 and the other site has Cisco ASA).
below are the details of the current setup:
Cisco Side: i have created two VPN connections each one connected to one ISP
and i configured IP-SLA between two ISPs, its working fine.
Juniper Side: i have two ISPs for each connected to a deffirent interface(eth0/1 , eth0/2), i have created two route based VPNs(one on each interface)...
what i need is to configure auto failover between these two sites, what i found over the furoms is to configure track-IP which will not be available by design because of NSRP enabled...
is there any other way to configure the auto failover on juniper ssg?
i can switch to policy based VPN if needed, but i need your assistance on the failover...
regards,
Amjad.